How to check and refill power steering fluid on a 1967 Shelby GT500?

Model: 1967 Shelby GT500

If you own a classic 1967 Shelby GT500, ensuring that all its mechanical aspects are in top shape is crucial for both performance and safety. One important, yet sometimes overlooked, component is the power steering system. If you notice your steering becoming more difficult, noisy, or less responsive, it might be time to check and refill the power steering fluid. Here is how to solve this issue:

Step 1: Preparation

To begin, make sure the car is parked on a flat surface and the engine is turned off. Open the hood by pulling the hood release lever under the dashboard. Secure the hood with the hood prop rod if necessary.

Step 2: Locate the Power Steering Reservoir

The power steering fluid reservoir is typically located in the engine bay on the driver's side. On the 1967 Shelby GT500, look for a small, round metal canister with a screw-on cap. The cap might have a small dipstick attached to it for checking the fluid level.

Step 3: Checking the Fluid Level

Carefully unscrew the cap from the power steering reservoir. You will notice an attached dipstick. Wipe the dipstick clean with a rag or paper towel, then reinsert it fully into the reservoir. Remove it again to check the fluid level. The dipstick should indicate the proper level range, either "FULL" and "LOW" or similar markings.

Step 4: Refilling the Power Steering Fluid

If the fluid level is below the recommended range, it's time to refill. Use only the type of power steering fluid specified for your 1967 Shelby GT500, which can be found in the vehicle's owner’s manual. Pour the fluid slowly into the reservoir using a funnel to avoid spills. Periodically check the level with the dipstick to ensure you do not overfill.

Step 5: Rechecking and Closing

After refilling, reinsert the dipstick and check the level one last time. Once the fluid is at the correct level, screw the cap on tightly to secure the reservoir. Wipe away any spilled fluid using a clean rag.

Step 6: Testing the System

Start the engine and turn the steering wheel from lock to lock a few times to circulate the new fluid through the system. Listen for any unusual noises and feel for smoother operation. Shut off the engine and check the fluid level once more to ensure it remains within the recommended range, adding more if necessary.

Final Touch

Close the hood securely and take your Shelby GT500 for a short drive to ensure everything operates smoothly. Regular checks and maintenance of your power steering fluid can greatly enhance the drivability and lifespan of your classic muscle car.

By following these detailed steps, you can confidently check and refill the power steering fluid on your 1967 Shelby GT500, ensuring it remains a joy to drive.