How to change the oil on a 1971 Dodge Charger R/T?

Model: 1971 Dodge Charger R/T

Changing the oil in your 1971 Dodge Charger R/T is crucial for maintaining the vehicle's performance and extending its lifespan. Neglecting this essential maintenance task can lead to poor engine efficiency, increased wear and tear, and even serious damage over time. Don’t worry; here is how you can solve this issue and keep your classic car running smoothly.

Step 1: Gather Necessary Tools and Supplies

Before you start, ensure you have the following: fresh motor oil (check your owner's manual for the correct type and quantity), a new oil filter, a wrench set, an oil filter wrench, a drain pan, and a funnel.

Step 2: Prepare the Vehicle

Park your Dodge Charger R/T on a level surface and engage the parking brake. If needed, raise the front of the car using a jack and secure it on jack stands for better access to the underside.

Step 3: Locate the Oil Drain Plug

Slide under the car and locate the oil drain plug. It's situated at the bottom of the oil pan, typically towards the rear of the engine. The oil drain plug is a metallic bolt that can be unscrewed with a wrench.

Step 4: Drain the Old Oil

Place the drain pan directly beneath the oil drain plug. Use a wrench to carefully loosen and remove the plug, allowing the old oil to flow into the pan. Be cautious as the oil might be hot if the engine was recently running. Let all the oil drain out completely.

Step 5: Remove the Old Oil Filter

Locate the oil filter, which is generally found on the side of the engine block. It is a cylindrical component that can be unscrewed using an oil filter wrench. Turn it counterclockwise to remove it. Be prepared for some oil to spill during this process.

Step 6: Install the New Oil Filter

Take the new oil filter and apply a small amount of fresh oil onto the rubber gasket to ensure a good seal. Screw the new filter into place by hand, turning it clockwise until it is snug. Do not over-tighten it.

Step 7: Replace the Oil Drain Plug

Once the old oil has fully drained, clean the drain plug and the area around it. Reinstall the oil drain plug by screwing it back into its original position, ensuring it is secure but not over-tightened.

Step 8: Add New Oil

Open the hood and locate the oil cap, usually found at the top center of the engine. It's a round plastic cap with an oil can symbol on it. Remove the cap and use a funnel to pour the new motor oil into the engine. Refer to your owner’s manual for the exact amount required.

Step 9: Check the Oil Level

After adding the new oil, use the dipstick to check the oil level. The dipstick is typically a long, thin metal rod attached to a handle, located near the front of the engine compartment. Pull it out, wipe it clean, reinsert it fully, then pull it out again to check the level. Ensure the oil level is within the marked range.

Step 10: Recycle the Old Oil

Dispose of the old oil and filter responsibly by taking them to a recycling facility or an auto parts store that accepts used motor oil.

By following these steps, you can efficiently change the oil on your 1971 Dodge Charger R/T, ensuring your vehicle continues to run at its best. Regular oil changes are key to preserving the life of your engine and maintaining peak performance.