How to adjust the timing on a 1970 Chevrolet Chevelle SS 454?

When your 1970 Chevrolet Chevelle SS 454 is running roughly or hesitating during acceleration, it might be due to the engine's timing being off. Proper ignition timing is critical for the performance…

How to adjust the timing on a 1970 Chevrolet Chevelle SS 454?

When your 1970 Chevrolet Chevelle SS 454 is running roughly or hesitating during acceleration, it might be due to the engine's timing being off. Proper ignition timing is critical for the performance and longevity of your engine. Incorrect timing can cause poor fuel efficiency, knocking, and even engine damage. Here is how to solve this issue:

Join the AutoFame community. Become a member for free, add your car to the garage and tell its story. Join AutoFame.

Step 1: Gather Necessary Tools and Equipment

Before you begin, ensure you have the following tools on hand:

Step 2: Locate the Timing Marks

Open the hood and locate the timing marks on the engine. These are typically on the timing chain cover, near the harmonic balancer, at the front of the engine. The harmonic balancer is a round metal wheel attached to the crankshaft, usually at the bottom center front of the engine.

Step 3: Clean the Timing Marks

Before adjusting, ensure the timing marks are properly visible. Use a rag to clean off any dirt or grease. You can enhance their visibility by marking them with chalk or a bright marker.

Step 4: Attach the Timing Light

Find the number one spark plug wire. This is usually the first plug wire on the driver’s side front of the engine. Attach the timing light’s inductive pickup to this spark plug wire. Connect the timing light’s power leads to the car battery: red to positive and black to negative.

Step 5: Warm Up the Engine

Start the engine and let it idle until it reaches its normal operating temperature. This ensures the engine is in the condition it normally operates in for accurate timing adjustment.

Step 6: Point the Timing Light

Aim the timing light at the timing marks you cleaned and highlighted earlier. The light will flash in sync with the ignition, illuminating the timing marks.

Step 7: Check the Timing

Compare the illuminated timing marks against the factory specifications for your 1970 Chevrolet Chevelle SS 454. Refer to your service manual for the correct base timing setting.

Step 8: Loosen the Distributor Hold-Down Bolt

The distributor hold-down bolt is typically located at the base of the distributor, which is usually toward the rear of the engine. Use a distributor wrench to slightly loosen the bolt, just enough that you can gently rotate the distributor.

Step 9: Adjust the Timing

With the engine running and the timing light pointing at the marks, slowly rotate the distributor. Clockwise rotation typically advances the timing, and counterclockwise retards it. Adjust until the timing mark aligns with the correct timing setting on the balancer.

Step 10: Tighten the Distributor Hold-Down Bolt

Once the timing is correctly set, securely tighten the distributor hold-down bolt to lock the distributor in place.

Step 11: Turn Off the Engine and Disconnect Tools

Turn off the engine and carefully disconnect the timing light and any other tools used.

Have a car with a story like this? Become an AutoFame member and share it with people who love cars as much as you do.

Step 12: Test Drive

Take your Chevrolet Chevelle SS 454 for a test drive to ensure it’s running smoothly and performing well. Listen for any unusual sounds and check for responsiveness.

By following these steps, you can accurately adjust the timing on your 1970 Chevrolet Chevelle SS 454, ensuring it runs optimally.

About AutoFame

AutoFame is a home for people who love cars and the stories behind them. Every car on a show field or in a garage has a history: who built it, who saved it, the road trips, the late nights in the shop and the people who helped along the way. AutoFame gives those stories a place to live, so they are not lost when the hood closes or the car changes hands.

Membership is free. Once you join, you can add your car to your own AutoFame garage with photos, specs and the story only you can tell. Restorations, survivors, daily drivers, race cars and family heirlooms all belong here. Other members can find your car, follow its progress and connect with you over the details that matter to car people.

Beyond member garages, AutoFame publishes stories, guides and features on the cars, builders and history that shape car culture. You will find buying and restoration guides, car parts explainers, special editions, the newest models and the classics that started it all. The AutoFame Gallery puts member cars on display for anyone to browse, and the AutoFame YouTube channel adds owner interviews, show highlights and the conversations that happen around a good car.

AutoFame is also built for the people who run car shows. Organizers use it to manage entries and judging, and judges score each car category by category on their phones, with a written guide for every category so nothing gets skipped. After a judged show, owners can see what their car was scored on and how it compared. Shows across the Texas Gulf Coast have run on AutoFame, including the Moody Gardens Car Show in Galveston, Good Grub and Gears, and Keels and Wheels at Lakewood Yacht Club.

AutoFame was founded by Kevin Brady, whose own life in cars began long before he started building tools for the hobby. The idea is simple: the people who love these cars should have one place to share them, learn from each other and keep the stories going.

Whether you own a show winner, a project that is still in pieces or simply love reading about great cars, there is room for you here.

Be part of the AutoFame community. Join free and become a member today.

All storiesFind an event AboutContactPrivacy

© 2026 AutoFame